Doesn’t look too out of the ordinary for me. The windows on the side of the building and also the irregular escape stairs are things you see often enough in real life. The water tower on top of the building is not too strange either.

The scaffolding on the left looks like it has a printed net in front of it with a picture of the building how it looked like (or how it should look like), again, nothing I have not seen before…

I can not see anything strange with the humans other than the very noisy picture.

Likely just good ol‘ photoshop

I wouldn’t know. All I am saying is that Syncthing would not work for this purpose.

Syncthing works on a file level basis. If files are changed on both devices at the same time, it will have sync conflicts.

Yep, that’s the beginning of climate change scientists have warned about since ages.

Don’t worry, it will get worse in the next years.

I don’t think that is illegal now. As you are technically not an insider

Dude. Did you even read what I wrote? PNG is bad for photos. Your example is a photo. Go ahead and try the same with a screenshot with text and menus showing.

We can ask the same the other way around: why do you want to use jpg if it results in a bigger size and worse quality than png?

JPEG for graphics like screenshots is not very efficient. For stuff like that, png is simply superior. (But not with compression 0)

PNG is not good for photos though.

Why 0 compression?

What format are you saving them in? BMP? Try png.

Maybe you didn’t raise it enough? It is definitely the sign of being too close to the bed.

There is no shortage on frontend alternatives for PC… but somehow I have yet to find anything worth mentioning for iOS

Thanks!

I have done something similar by purposefully adding patterns on the bottom of a 3D model.

Ok, let’s look into it. (you can also send me your printer.cfg if you want) The Mini e3 v3 has the following switchable outputs:

• HB - PC9
• E0 - PC8
• FAN0 - PC6
• FAN1 - PC7
• FAN2 - PB15

Keep in mind that they all switch ground only. 24V is always there.

You can use all of them for whatever you want, Klipper is very flexible here. HB is your heated bed, no questions here. E0 should be connected to your Hotted board HE0. I don’t know which of the fans on your board does what, you may need to connect them all and see which one does what (I guess your hotend does not have 3 fans). in the end you want [hotend_fan] to be the one calling the hotend (not the part!). the [fan] will be controlled by the slicer (overhangs, bridges and so on).

DCIN on your board should ideally be connected directly to the PSU, you do not want it to be switched.

don’t worry, we will get you back printing.

Glad to be of help!

The FAN1 in this case can not be controlled by software. It will always be on as soon as the printer is powered.

Then suddenly all VPN providers will be „commercial“.

An exclamation mark (!) inverts a pin. The other symbol (^) enables a pull up resistor on a pin, which is needed for things like endstops or buttons. These can also be combined.

PB0 is just the name of one pin. PC0 would be a completely different pin.

Different Microcontrollers have different naming conventions, that is why you sometimes see names like PB10 and on other controllers it might be GPIO10.

See also the documentation: https://www.klipper3d.org/Config_Reference.html

So how would that work? You can not distinguish between commercial or private use, because the traffic is encrypted, you don’t know what is transmitted, that is the whole point.