Here you go ;) https://lemm.ee/post/35636122
I 100% agree with you, a professionally made dial is a work of art and should be absolutely perfect at any magnification. This is just a fun, cheap summer watch project for my own enjoyment ;)
The best looking alternative would have been to have the logo made by electroforming. They look perfect and very professional. Unfortunately the MOQs are usually quite large and therefore expensive, I couldn’t justify spending half the price of this project just on a logo (even if I had enough spare logos for several lifetimes).
Thanks for the feedback!
I’m pretty happy with the transparencies tbh. Although on mine, there seems to be two sides, one that gives a fuzzy dirty effect with a lot of stray toner around the actual print (looks like static), and the other side that gives perfectly crisp prints. Unfortunately I can’t really tell the sides apart.
Apart from that small speck of dust that prevented the transfer at the top left of the logo, the sheet came out perfectly clean, the totality of the toner was transferred to the dial. For PCB transfers where you could probably keep the sheet intact (I had to cut mine to fit between the applied indices), that would also mean the sheet would be almost indefinitely reusable.