I’m practicing for my driving licence and I’m going to driving school, just out of curiosity though I’ve looking on YouTube how to start and run a car and I’ve seen at least 3 different methods, I dunno which one is the correct. Things like the order when you release a pedal or when you need to press the clutch keep switching…
No. If the clutch is in, there is no need to put in neutral. (You would not pass the driving test in Germany)
The correct steps are:
Right foot press down on the brake
Left foot press down on the clutch
Start the engine
check that the 1. gear is in
Then release the brake, get on the gas just a little, release the clutch carefully, and there you go.
Lol, I’m not from Germany but I seriously doubt they’d fail you in a driving test because you put the car in neutral before you start it. That’s just ridiculous.
It is OK if you put the 1. gear in before you start the engine, but you should not put in neutral.
Warum? War bei mir damals™ nicht so, eher im Gegenteil. Erstmal checken, ob auch ja kein Gang eingelegt ist.
Möglicherweise haben sie die Regeln irgendwann geändert, das weiß ich nicht.
Justify that, please.
I hit a barn with a dump truck because the clutch pedal failed to disengage the clutch, and I was in first gear when I tried to start. In neutral, the truck would not have lurched forward, and I would have discovered the problem when I couldn’t slip the transmission into reverse.
The transmission should be in neutral until the hand brake/parking brake is released, and you are ready for the vehicle to move.
Then your right foot was not firmly on the brake, see step 1.
I got a minor error on my test in the UK for “unnecessarily touching the gear stick” so …
That’s insane. Starting in neutral is arguably safer.
Disagree.
It is possible for the clutch pedal to fail to disengage a malfunctioning clutch, or for a clutch cable to part while the vehicle is being started. In either case, the vehicle will lurch when in gear and the starter is actuated.
I know it is possible, because I hit the back wall of a barn with a dump truck when it happened to me.
Except for emergency scenarios (roll starting, or trying to use the starter motor to move an otherwise disabled vehicle), the transmission should be in neutral when starting, and not shifted out of neutral until the hand brake is released.
I guess they just don’t use broken cars in the driving test.
Excuse me, Whatthefuck.
Mechanical shit breaks, things go wrong. Standard practice should be to operate in such a manner as to minimize danger to life and property when shit breaks and things go wrong.
Offer a reasonable explanation for why the transmission should be in first gear. If that explanation is some variation of “This authoritarian that said to do it this way”, ignore them with extreme prejudice and do it the right way.
No, I do not excuse foul language, and this will be my last response for you.
The question here was about a driving test, not about some mechanical science. Case closed.
I will note that I didn’t ask you to excuse my foul language. I was addressing your condescending horseshit comment.
Assuming you have accurately represented German testing standards (which doesn’t seem likely), the proper course of action here is to either provide the requested explanation, or petition the German government to correct this error.
Why would they fail you for putting the car in neutral and pushing the clutch in before you start the car?
What are you supoosed to do if you want to let the car warm up or you’re waiting for someone or any other reason you want to start the car but not immediately start driving? Are you supposed to put it in first, push in the clutch, start the car and then just leave the clutch pushed in for 5 minutes?
LOL
Guess what: You are supposed not to do it.
That is explicitly forbidden in Germany, for the sake of the environment.
Older (pre 2000) diesel cars needed a few seconds, sometimes a minute to “warm-up” the starter. You had to turn the ignition half way before you actually start the car. That’s the only “warming up” a car might need to function (normal circumstances).
Glow plugs. They needed time to heat the glow plugs, which look like spark plugs, but function like an incandescent light bulb. They would be a nice hot spot in the cylinder to help ignite the fuel and get the engine started.
While the engine doesn’t need to be warmed up anymore, the HVAC system may need the engine to be hot before it can keep the windshield defogged and ensure the driver’s view remains unobstructed.
That’s not warming up the starter, that’s warming up the glow plugs. And turning on the ignition doesn’t require you to be in neutral or press the clutch, since it doesn’t turn the engine
…how do you demist your cars?
Not sure if I understand. Tell me more details.
Until the engine warms up, I can’t keep the windscreen from misting up in the winter. Especially if it’s frosted on the outside!
You fix your leaky weatherproofing and put a dehumidifier inside overnight to get rid of the leftover moisture. Afterwards your windows will no longer mist up.
Fix the issue instead of treating the symptoms
Modern car engines would need a very long time to warm up in idle anyways, and modern cars usually have electronic defrosters for the windshield
The outside is the easy part (unless there is thick ice): use the water spray with the wipers. In the winter, the water contains a thawing solvent.
For the inside, what I personally do in the winter: before parking my car in the evening, I open all the windows for a few minutes to let the cold air in (also switch off the heating). Cold air is very dry. So it does not mist up (most times) in the morning.
It’s a wet morning and the inside of your windshield is fogged up. (Or it’s cold and there’s frost on the inside)
Most people take a rug or a sponge and wipe the windshield. Then after starting, the air condition helps.
Some cars have a heatable windshield. All have a heatable rear window.
lol I guess I shouldn’t expect more from a country where the AFD is running away with elections
I guess countries are not made for your expectations…